Computer Setup-Power; Computer Setup-Boot - Compaq 100eu - All-in-One PC Maintenance & Service Manual

Computer Setup—Power
NOTE: Support for specific Computer Setup options may vary depending on the hardware
configuration.
Table 2-3 Computer Setup—Power
Option
After AC Power
Failure
S5 Maximum Power
Savings
WOL in S5
NX (No Execute)
Virtualization
Technology
Computer Setup—Boot
NOTE: Support for specific Computer Setup options may vary depending on the hardware
configuration.
Table 2-4 Computer Setup—Boot
Option
Boot-time
Diagnostic Screen
Boot Device
Priority
8 Chapter 2 Computer Setup (F10) Utility
Description
Allows you to select system restart behavior after power loss:
●
Stay Off - keeps power off until the power button is pressed.
● Power On - restores power as soon as power is applied.
●
Auto - restarts the computer if it was on before power failure; stays off if the computer was
not on.
Disables/enables S5 Maximum Power Savings. Enabling this feature reduces the power of this
system as much as possible in the S5 state. This feature must be disabled if you want to enable
Wake on LAN from S5.
Disables/enables limited Wake on LAN from S5. Note that the computer can only wake from S5
during a normal shutdown event. The S5 Maximum Power Savings feature must be disabled in
order to enable limited Wake on LAN from S5.
Allows you to disable/enable the processor's NX feature.
Allows you to enable/disable the processor's Virtualization Technology feature.
Description
Disables/enables POST diagnostic messages display during boot.
Allows you to specify which device groups will boot first, second, third, and fourth or to disable any of
the four. Also allows you to set the device boot priority within each group.
1st Boot Device Allows you to set the device group boot priority:
●
2nd Boot Device CD-ROM Group
3rd Boot Device ● HDD Group
●
4th Boot Device Floppy Group
● Network Boot Group
NOTE:
DOS operating system has started.
MS-DOS drive lettering assignments may not apply after a non-MS-