Card Reader
Description
Card reader
The card reader is housed in a bracket, and the assembly secured to the front of the computer with
one screw.
The card reader can be removed from the bracket by removing two screws.
1.
Prepare the computer for disassembly
2.
Remove the computer access panel
3.
Remove the front bezel
4.
Remove the optical drive
5.
Disconnect the card reader cable from the white system board connector (USB1).
NOTE:
6.
Remove the silver Torx screw (1) that secures the card reader assembly to the chassis.
7.
Pull the assembly away from the chassis (2) while guiding the wires through the hole in the front
of the chassis.
Figure 7-24
98
Chapter 7 Removal and Replacement Procedures Small Form Factor (SFF) Chassis
(Front Bezel on page
(Removing an Optical Drive on page
The cable connects to only half of the system board connector pins.
Removing the Card Reader
(Preparation for Disassembly on page
(Access Panel on page
79).
Spare part number
622193-001
77).
78).
87).