Driver Board - Compaq 100eu - All-in-One PC Maintenance & Service Manual

Driver Board

Description
Driver board PHB (for panel)
The driver board is mounted atop the optical drive cage. The board connects three display cables and
is secured with two screws.
1. Prepare the computer for disassembly (see
on page
2. Remove the stand (see
3. Remove the hinge cover (see
4. Remove the memory/optical drive cover (see
5. Remove the rear cover (see
6. Remove the rear metal cover (see
7. Disconnect the two LIF connectors on the top of the board (1) and the connector on the bottom
of the board (2).
8. Remove the two silver Torx 2.5x7.0 screws that secure the board to the computer (3), and then
lift the board up and out of the computer..
Figure 8-16
To replace the driver board, reverse the removal procedures.
122 Chapter 8 Removal and Replacement Procedures All-in One (AIO) Chassis
106).
Stand on page
Hinge Cover on page
Rear Cover on page
Removing the driver board
Preparing to disassemble the computer
111).
112).
Memory/Optical Drive Cover on page
113).
Rear Metal Cover on page
Spare part number
623388-001
107).
118).