Removing A Xenpak Module - Extreme Networks Summit 300-24 Hardware Installation Manual

Installing the Summit Option Card and XENPAK Modules
To install XENPAK modules:
1 Hold the module by its sides and insert it into one of the two slots on the Summit option card
(Figure 184).
Figure 184: Installing a XENPAK module
XENPAK Module
2 Slide the XENPAK module as far into the slot as possible, until you hear it click, indicating that it is
firmly attached.
3 Secure the XENPAK module to the option card by turning the captive screws clockwise until they
are hand-tight.
4 Store the antistatic container, dust covers, and card-edge connector protective pad in a clean location
in case you need to remove the XENPAK module.
5 Remove the dust covers from the module connectors before you connect cables.
6 If only one XENPAK module is installed, attach a supplied cover plate over the other module slot.
NOTE
To ensure that your module is undamaged upon installation, you can correlate factory test data with
your installation site test data by consulting the average power reference values shown on the XENPAK
module test data sheet (Part No. 121074-00) enclosed with your module.

Removing a XENPAK Module

To remove a XENPAK module:
1 Disconnect the fiber-optic cable from the XENPAK module and install dust covers over the module
connectors.
WARNING!
Disconnect the fiber-optic cable from the XENPAK module before removing the module from the
Summit option card.
2 Turn the two captive screws counter-clockwise until they are completely free from the XGM-2xn
card.
372
Cover Plate
ES4K043
Extreme Networks Consolidated "i" and "e" Series Hardware Installation Guide