Extreme Networks Summit 300-24 Hardware Installation Manual page 203

Table 40: Alpine I/O module LEDs (green stripe) (continued)
LED
Port
(all except
FM-24MFi and
FM-24SFi)
Port
(FM-24MFi and
FM-24SFi only)
Table 41 describes the LED activity on the Alpine Access I/O modules with the silver stripe (for
example, the WM-4T1i, WM-4E1i, and WM-1T3i I/O modules).
Table 41: Alpine Access I/O module LEDs (silver stripe)
LED
Status
Diag 1
WAN port
(1-4)T1/E1
(1)T3
10/100 port
(5,6)T1/E1
(2,3)T3
1 The Diag LED is on the WM-4T1i module only.
2 The rapidly blinking LEDs cycle twice a second.
3 The slowly blinking LEDs cycle once per second.
Table 42 describes the system LED activity on the Alpine PoE modules (for example, the FM32Pi I/O
module). Both system and per-port LEDs are present on the module under software control.
Extreme Networks Consolidated "i" and "e" Series Hardware Installation Guide
Color Indicates
Green Link up
Flashing green Disabled
Amber Packet activity
Off Link down
Green Link up
Flashing green Packet activity
Off Link down
Color/State
Off
Amber
Green
Green blinking
Off
Amber
Amber rapidly blinking 2
Amber slowly blinking 3
Green
Alternating green and amber
2
Green rapidly blinking
Green slowly blinking 3
Off
Green
Alternating green and amber
Indicates
No power
Module seated in chassis
Module powered up
Power-on Self Test (POST) is running
Normal operation
Near-end fault has been detected (for example, no
cable)
Far-end fault has been detected
Physical link is present, but no higher-layer link
(port is misconfigured or disabled)
Physical link is present, higher-layer link is
established, but no traffic is present
Physical link is present, higher-layer link is
established, and traffic is present
Loopback testing mode is in progress
Port is active, but disabled
No link is present
Link is present
Traffic is present
Configuring I/O Modules
203