Fm-24Sfi Module - Extreme Networks Summit 300-24 Hardware Installation Manual

Configuring I/O Modules

FM-24SFi Module

Figure 107 shows the FM-24SFi module.
Figure 107: FM-24SFi module
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
Module status LED 100 Mbps ports
with status LEDs
FM-24SFi
The FM-24SFi module has 24 100 Mbps Ethernet ports, using standard MT-RJ connectors. The FM-24SFi
module supports 100BASE-FX in single mode only.
The default configuration of the FM-24SFi module is as follows. All ports:
• Are added to the default VLAN as untagged.
• Inherit the properties of the default VLAN (protocol type, VLANid, and so forth).
• Operate in 100 Mbps, single mode. Half-duplex mode is not supported.
The total optical system budget for the FM-24SFi module is 11 dB. Measure cable plant losses with a
1310 nm light source to verify that your cable plant losses are within the optical budget. Table 108 on
page 346 describes the optical specifications for the FM-24SFi module.
LEDs
The FM-24SFi module has the following LEDs:
• Module status
• Port status
For information about the LEDs and their activity on the FM-24SFi module, see "I/O Module LEDs" on
page 202.
Software Requirements
The FM-24SFi module requires ExtremeWare version 6.1.7 or later and BootROM 6.5 or later on the
switch.
Extreme Networks Consolidated "i" and "e" Series Hardware Installation Guide 193