F32Fi Module - Extreme Networks Summit 300-24 Hardware Installation Manual

F32Fi Module

Figure 160 shows the F32Fi module.
Figure 160: F32Fi module
Module status LEDs
1 9 17 25
2 10 18 26
3 11 19 27
Port status LEDs
4 12 20 28
5 13 21 29
6 14 22 30
7 15
23 31
8 16 24 32
1 17
4 20
5 21
100 Mbps
8 24
9 25
ports
12 28
13 29
16 32
All F32Fi ports have 32 100BASE-FX ports and use standard MT-RJ connectors.
The default configuration of the F32Fi modules is as follows. All ports:
• Are added to the default VLAN as untagged.
• Inherit the properties of the default VLAN (protocol type, VLANid, and so forth).
• Operate in 100 Mbps, full-duplex mode. Half-duplex mode is not supported.
LEDs
The F32Fi module has the following LEDs:
• Module status
• Port status
For information about the LEDs and their activity on the F32Fi module, see "I/O Module LEDs" on
page 293.
Software Requirements
The F32Fi module requires ExtremeWare version 6.1.8 or later and BootROM 6.5 or later.
Extreme Networks Consolidated "i" and "e" Series Hardware Installation Guide
BD_F32Fi
Configuring I/O Modules
279