Extreme Networks Summit 300-24 Hardware Installation Manual page 131

If your switch has two power supplies, align the retaining brackets so that the retaining bracket
screws do not interfere with each other. Figure 71 and Figure 72 show typical bracket orientations.
Figure 71: Attaching two retaining brackets—first example
Figure 72: Attaching two retaining brackets—second example
Retaining bracket screw
Retaining bracket screw
7 Tighten the retaining bracket screw to secure the bracket around the power connector.
8 Connect the power cable to the power source.
9 If the switch has a power switch, set the power switch to the ON position.
Extreme Networks Consolidated "i" and "e" Series Hardware Installation Guide
Installing the AC Power Cable Retaining Bracket
Retaining bracket screw
Retaining bracket screw
LB48022A
SH_002
131