Summit Switch Models
CAUTION
Only trained service personnel should perform service on Summit1i power supplies.
Label
The label on the rear of the Summit1i switch displays important information about the switch. Write
down the following information before you install the switch:
• Model number—Model number assigned to this device
• Part number—Part number assigned to this device
• Serial number—Manufacturing serial number for this device. Refer to the serial number when you
contact Extreme Networks technical support
• MAC address—Unique Ethernet MAC address assigned to this device
Reset Button
Use the reset button to cycle the switch down and bring the switch back up without powering off the
switch. Your saved switch configuration information is not lost; unsaved switch configurations are lost.
Use a non-conductive tool to push the reset button.
Console Port
Use the console port (9-pin, "D" type connector) for local management. This port allows you to attach a
terminal for access to the CLI through a serial connection.
Summit5i Switch
The Summit5i switch is 2U high; it is available in three port configurations:
• 12 autosensing 100BASE-TX/1000BASE-T ports with RJ-45 connectors and 4 1000BASE-X ports with
SC connectors (Figure 38)
• 12 1000BASE-SX ports with MT-RJ connectors and 4 1000BASE-X ports with SC connectors
(Figure 39)
• 12 1000BASE-LX ports with either MT-RJ or LC connectors (Figure 40 shows LC connectors) and
4 1000BASE-X ports with SC connectors (Figure 40)
To determine the type of connectors on your Summit5iLX switch, look at the serial number on the
rear of the switch. Serial numbers that start with 0233 and lower have MT-RJ connectors. Serial
numbers that start with 0234 and higher have LC connectors. For example, a Summit5iLX switch
with the serial number 0234M-00012 has LC connectors.
90
Extreme Networks Consolidated "i" and "e" Series Hardware Installation Guide