Installing A Blackdiamond 6800 Series Ac Power Supply - Extreme Networks Summit 300-24 Hardware Installation Manual

Figure 135: Orientation of the AC power supply in a BlackDiamond 6808 or a BlackDiamond 6804
POWER
V-50/60Hz
200-240V, 15A
CAUTION
Do not handle the power supply using the DC output bus bars. Support the power supply from the
bottom, while holding the handle on the front of the power supply unit.
Figure 136: DC output bus bars and connectors on a BlackDiamond power supply

Installing a BlackDiamond 6800 Series AC Power Supply

To install a power supply:
1 Attach the ESD strap to your wrist and connect the metal end to the ground receptacle on the top
left corner of the switch front panel.
2 Verify that the rack and chassis are grounded to protective earth ground.
3 If a blank faceplate is covering the power supply bay, remove it and save it for future use.
Extreme Networks Consolidated "i" and "e" Series Hardware Installation Guide
DC OUT
AC IN
50021
Connectors Bus bars
Installing a BlackDiamond 6800 Series AC Power Supply
BD_033
XM_busbar
243