Console Port; Port Connections - Extreme Networks Summit 300-24 Hardware Installation Manual

Table 11: Summit 200 switch LED activity
Unit Status LED (MGMT LED)
Color
Green solid
Green blinking
Amber
Off
Fan Status LED
Color
Green
Amber blinking The fan system has a failure.
Port Status LEDs
Color
Green
Green blinking
Off
Fiber Port Status LEDs (Ports 25 and 26 or Ports 49 and 50)
Color
Green
Green blinking
Off
Unit Stacking ID Number LED
Color
N/A

Console Port

Use the console port (9-pin, "D" type connector) for connecting a terminal and carrying out local
management.

Port Connections

A Summit 200-24 or 200-48 switch has either 24 or 48 10BASE-T/100BASE-TX ports using RJ-45
connectors for communicating with end stations and other devices over 10/100Mbps Ethernet.
Extreme Networks Consolidated "i" and "e" Series Hardware Installation Guide
Indicates
The Summit switch is operating normally.
The Summit switch power-on self test (POST) is in progress.
The Summit switch has failed its POST or an overheat condition
is detected.
There is no power.
Indicates
The fan is operating normally.
Indicates
Link is present; port is enabled.
Link is present, port is enabled, and there is activity on the port.
Link is not present or the port is disabled.
Indicates
Link is present; port is enabled.
Link is present, port is enabled, and there is activity on the port.
Link is not present, port is disabled, non-supported GBIC is
installed on the port, or the RJ-45 uplink port is in use instead of
the fiber port.
Indicates
When several Summit "e" series switches are interconnected
(stacked), each switch is assigned a unique stacking ID number
that is visible in the unit stacking ID number LED. The switch
acting as the stack master is usually assigned the number 1.
However, if there is a saved configuration or if you prefer to
assign a different stacking ID to the stack master, the stack
master can have an ID other than 1.
This LED is available only on the Summit 200-24 and 200-24fx
switches.
Summit 200 "e" Series Switches
63