Table of Contents
Advertisement
NOTE
To ensure that your module is undamaged upon installation, you can correlate factory test data with
your installation site test data by consulting the average power reference values shown on the XENPAK
module test data sheet (Part No. 121074-00) enclosed with your module.
Removing a XENPAK Module
To remove a XENPAK module:
1 Disconnect the fiber-optic cable from the XENPAK module and install dust covers over the module
connectors.
WARNING!
Disconnect the fiber-optic cable from the XENPAK module before removing the module from the
Summit option card.
2 Turn the two captive screws counter-clockwise until they are completely free from the XGM-2xn
card.
WARNING!
XENPAK modules become very hot after prolonged use. Take care when removing a XENPAK from
the chassis. If the module is too hot to touch, disengage the module and allow it to cool before
removing it completely.
3 Holding both captive screws, pull the XENPAK module out of the card.
4 Place the dust covers back into the XENPAK module connectors.
5 Place the XENPAK module immediately into an antistatic container to protect it from ESD damage
and dust.
6 If you are not installing another XENPAK module, cover the opening with a cover plate.
Extreme Networks Consolidated "e" and "i" Series Hardware Installation Guide
Removing a XENPAK Module
381
Advertisement
Table of Contents
