Attaching The Connector To The Dc Power Supply - Extreme Networks Summit 300-24 Hardware Installation Manual

NOTE
Each wire on the harness has been properly marked for proper attachment to the DC power source.
Leave these labels on each lead wire for future reference.

Attaching the Connector to the DC Power Supply

DC input power is provided through a three-pin connector on the front panel of the DC power supply.
To attach the cable to the Summit48si DC power supply:
1 Plug the three-wire cable harness onto the connector on the front of the power supply.
The pins must align properly for the cable to completely connect. Do not force the cable onto the
connector until the keyway is aligned properly.
2 Tighten the retainer nut on the connector until it is finger tight.
3 Secure the tray cable near the rack framework using multiple cable ties to minimize the chance of the
connections being disturbed by casual contact with wiring. Use at least four cable ties separated
4 inches apart with the first one located within 6 inches of the terminal block.
NOTE
It is not necessary to switch off power from the source when removing the keyed connector from the
Summit48si DC power supply.
Extreme Networks Consolidated "i" and "e" Series Hardware Installation Guide
Installing the Summit48si Switch DC Power Supply
135