Removing The Switch From A Rack - Extreme Networks Summit 300-24 Hardware Installation Manual

Removing the Switch from a Rack

To remove the Summit switch from a rack, you need the following tools, equipment, and resources:
• Helper bracket (provided with the Summit7i switch)
• A minimum of four appropriate screws to secure the helper bracket (not provided)
• # 1 Phillips screwdriver
• If you have a Summit7i switch, a minimum of two people to help remove the switch from the rack
To remove the Summit switch from a standard 19-inch (48.26 cm) rack:
1 For AC-powered switches, unplug the power cable(s) from the from the wall outlet(s) and then from
the switch.
For a DC-powered Summit48si, disconnect the keyed DC cable connector from each installed power
supply.
2 Disconnect the Summit switch from the redundant power supply (if applicable).
3 If you are removing a Summit7i switch, mount the helper bracket in the rack directly beneath the
switch using four screws that are appropriate for your rack.
4 Unscrew the chassis from the rack.
5 Have a minimum of two people carefully remove the chassis from the rack and place it on a secure,
flat surface with the front of the chassis facing you.
6 Unscrew the helper bracket and remove it from the rack.
Extreme Networks Consolidated "i" and "e" Series Hardware Installation Guide
Removing the Switch from a Rack
115