Removing A Blackdiamond 8000 Series Module - Extreme Networks BlackDiamond 8800 Hardware Install Manual

Hide thumbs Also See for BlackDiamond 8800:

Table of Contents

information about the module (name, serial number, part number), the state of the module (power

down, operational, mismatch between the slot configuration and the module in the slot), and the

number of ports on the module.

For more information about slot status information, see the

ExtremeXOS Command Reference

Removing a BlackDiamond 8000 Series Module

Caution

BlackDiamond 8800, and 8900 Series modules have two styles of ejector/injector levers. Pay

careful attention to the instructions in step

This section describes how to remove modules from a BlackDiamond 8800 Series switch.

BlackDiamond modules are hot-swappable. You do not need to power the system off to remove a

module.

You need the following tools and equipment to remove a BlackDiamond 8500,8800, or 8900 Series

module:

•

ESD-preventive wrist strap

•

#2 Phillips screwdriver

•

Replacement module or blank front panel if you are not replacing the module

To remove a BlackDiamond module:

Attach the ESD-preventive wrist strap to your bare wrist. If it is not already connected, connect the

metal end to the ground receptacle at the top left corner of the chassis.

BlackDiamond 8800 Hardware Install Guide

Installing Modules and Establishing Initial Management Access

ExtremeXOS User Guide

Guide.

on page 96.

and the

Table of Contents