Extreme Networks Summit 300-24 Hardware Installation Manual page 72

Summit Switch Models
Table 13: Summit 300-48 switch LED activity (continued)
Power Supply Status LEDs
LED Color
OUT Solid Green
Off
TEMP Solid Amber
Off
IN Solid Green
Off
10/100 Mbps Port Status LEDs
Color
Green, solid
Green, fast blinking
Amber, solid
Amber, slow blinking
Amber, fast blinking
Alternating amber/green
Off
10/100/1000 Mbps Port Status LEDs
Color
Green solid
Green blinking
Amber blinking
Off
Fiber Port Status LEDs
Color
Solid Green
Blinking Green
Off
Console Port
Use the console port (9-pin, "D" type connector) for connecting a terminal and carrying out local
management.
Port Connections
The Summit 300-48 switch uses a combination of 10BASE-T/100BASE-TX ports using RJ-45 connectors
and Small Form Factor Pluggable (SFP) Gigabit Interface Connectors (GBICs), also known as
mini-GBICs.
72
Indicates
The output voltages are enabled and within specification.
There is a fault on at least one output voltage or voltages are out
of specification.
The fan failed or there is an over temperature condition.
The fan is operating normally and operating temperature is within
limit.
The input voltage is within specification and the input section is
working.
The input voltage is out of range or there is a fault in the input
section.
Indicates
Link is present and port is enabled; non-powered device.
Port is enabled; link is up, device non-powered and activity on the
port.
Link is present and port is enabled; device powered.
Link is down or port is disabled; device powered.
Port is enabled; link is up, device powered and activity on the
port.
There is a power fault.
The link is down or the port is disabled; non-powered device.
Indicates
Link is present; port is enabled; full-duplex operation.
Link is present; there is activity.
Reserved.
Link is not present or the port is disabled.
Indicates
Link is present; port is enabled; full-duplex operation.
Link is present; there is activity.
Link is not present; port is disabled; mini-GBIC is not installed.
Extreme Networks Consolidated "i" and "e" Series Hardware Installation Guide