Alpine 3802 Switch - Extreme Networks Summit 300-24 Hardware Installation Manual

Alpine 3800 Series Switch Models
Figure 78: Rear view of the Alpine 3804 switch
Label
V Hz A
100-120 50 13
200-240 60 6
6 60 200-240
13 50 100-120
REMOVE TO SLIDE A Hz V
45012
The rear panel of the Alpine 3804 switch provides:
• Access to the power supply
• Access to the grounding studs
• System label, which includes:
— Chassis serial number
— Ethernet MAC address of the switch
— Symbols of safety certification

Alpine 3802 Switch

The Alpine 3802 switch consists of the following components:
• One 3-slot chassis, 4 U high, with backplane
• Three I/O module slots, labeled slots 1 through 3
• One integrated management module
• One or two preinstalled power supplies, either AC or DC
• One built-in fan tray containing three fan units; this fan tray is not customer-serviceable.
• One connector for an electrostatic discharge (ESD) wrist strap
• Six light emitting diodes (LEDs)
CAUTION
The Alpine 3802 switch has an integrated Switch Management Module (SMMi). The integrated Switch
Management Module is not hot-swappable or user removable. Do not attempt to remove the integrated
Switch Management Module. Contact Extreme Networks Customer Support if you experience problems.
146
OK DC DC OK
WHEN INSTALLED IN 3804 THIS WAY UP
UP WAY THIS 3808 IN INSTALLED WHEN
SERVICE
Grounding
studs
Blank for
second
power
supply
Power
supply
38_rear4
Extreme Networks Consolidated "i" and "e" Series Hardware Installation Guide