Installing An Alpine 3808 Or Alpine 3804 Ac Power Supply - Extreme Networks Summit 300-24 Hardware Installation Manual

Installing and Connecting Alpine 3800 Series Switch Power Supplies
Table 30: Supported power supplies for the Alpine 3800 series switch
Switch Model AC power supply
Alpine 3808 1 Up to two AC power supplies
can be installed.
Alpine 3804 Up to two AC power supplies
can be installed.
Alpine 3802 Up to two AC power supplies
can be installed.
NOTE
If you require DC power supplies in the Alpine 3802 switch, two power supplies must be installed. The
Alpine 3802 switch does not support a DC power configuration using only a single power supply.
Installing an Alpine 3808 or Alpine 3804
AC Power Supply
This section describes how to install an AC power supply for either the Alpine 3808 or the Alpine 3804
switch. The Alpine 3802 switch power supply is preinstalled at the factory.
Complete the following tasks before installing the power supplies:
• Ground the rack (see "Protective Grounding for the Rack (Alpine and BlackDiamond Switches)" on
page 40).
• Mount the chassis in a rack (see "Installing the Chassis in a Rack" on page 152).
• Ground the chassis (see "Grounding the Alpine 3800 Series Chassis" on page 155).
You need the following tools and equipment to install the Alpine 3808 and the Alpine 3804 AC power
supplies:
• ESD-preventive wrist strap (provided)
• # 2 Phillips screwdriver
To install an Alpine 3808 or Alpine 3804 AC power supply:
1 Attach the ESD strap to your wrist and connect the metal end to the ground receptacle on the top
right corner of the switch front panel.
2 If a blank faceplate is covering the power supply bay, remove it and save it for future use.
3 Prepare the power supply for installation:
• Use the text on the front of the power supply to ensure that it is oriented correctly for either the
Alpine 3808 or Alpine 3804.
• Move the safety latch to the "remove" position.
• Open the ejector/injector lever, as shown in Figure 87 and Figure 88.
160
DC power supply
Up to two DC power supplies
can be installed.
Up to two DC power supplies
can be installed.
Two DC power supplies must
2 be installed.
Hot-swappable
Yes
Yes
No
Extreme Networks Consolidated "i" and "e" Series Hardware Installation Guide