En81-1 Conform Wiring With One Motor Contactor - Omron VARISPEED L7 Manual

EN81-1 Conform Wiring with One Motor Contac-
tor
In order to use the L7Z with one motor contactor instead of two while keeping compliance to the
EN81-1:1998, the following rules have to be followed:
The hardware base block function using the terminals BB and BB1 must be used to enable / disable the
•
drive. The input logic must be PNP.
If the elevator safety chain is opened, the inverter output must be cut. This means that the base block sig-
•
nals at the terminals BB and BB1 must be opened, e.g. via an interposing relay.
The base block monitor function must be programmed for one of the multi-function outputs (H2-
•
46/47). The regarding digital output contact must be implemented in the contactor supervision circuit of
the controller in order to prevent a restart in case of an inverter base block or motor contactor malfunction.
All contactors must be conform to the EN81-1:1998, paragraph 13.2.
•
Fig 2.13 shows an EN81-1:1998 wiring example.
Fig 2.13 EN81-1 Conform Wiring with One Motor Contactor (Example)
Safety Chain
Circuit
The wiring rules and the wiring example are approved by the TUEV Sued, Germany. For more details please
contact your OYMC sales representative.
Elevator Controller
Contactor Close
Command
K01
24VDC *1
K1
BB BB1
Yaskawa
CIMR-L7xxxx
K2
Contactor Check
(Restart Permission)
Up/Down; Speed
selection; ...
BB Monitor
(NC)
M
=
2
21
2-