Omron VARISPEED L7 Manual page 218

Storing Inverter set values in the Digital Operator (READ)
To store Inverter set values in the Digital Operator use the following method.
Step
No.
1 Press the Menu Key and select advanced programming mode.
2 Press the DATA/ENTER Key.
Press the Increment and Decrement Key until parameter o3-01 is displayed (Copy Function
3
Selection).
4 Press the DATA/ENTER Key and select the constants setting display.
5 Change the set value to 1 using the Increment Key.
6 Set the changed data using the DATA/ENTER Key. The READ function starts.
7 If the READ function ends normally, "End" is displayed on the Digital Operator.
8 The display returns to o3-01 when a key is pressed.
If an error is displayed, press any key to cancel the error display and return to the o3-01 display. Refer to
page 7-16, Digital Operator Copy Function Faults
Writing Parameter Set Values Stored in the Digital Operator to the Inverter (COPY)
To write parameter set values stored in the Digital Operator to the Inverter, use the following method.
Step
No.
1 Press the MENU Key and select advanced programming mode.
2 Press the DATA/ENTER Key.
Explanation
for corrective actions.
Explanation
Digital Operator Display
-ADV-
** Main Menu **
Programming
-ADV-
Initialization
A1 - 00=1
Select Language
-ADV-
COPY Function
o3 - 01=0
Copy Funtion Sel
-ADV-
Copy Function Sel
o3-01= 0
*0*
COPY SELECT
-ADV-
Copy Function Sel
o3-01= 1
*0*
INV OP READ
-ADV-
READ
OP READING
INV
-ADV-
READ
READ COMPLETE
-ADV-
Copy Function Sel
o3 - 01=0
*0*
COPY SELECT
Digital Operator Display
-ADV-
** Main Menu **
Programming
-ADV-
Initialization
A1 - 00 = 1
Select Language
6
67
6-