Pg Speed Control Card Terminals And Specifications - Omron VARISPEED L7 Manual

Preventing C and D Option Card Connectors from Rising
After installing an Option Card into slot C or D, insert an Option Clip to prevent the side with the connector
from rising. The Option Clip can be easily removed by holding onto the protruding portion of the Clip and
pulling it out.
A Option Card mounting spacer hole
CN4
A Option Card connector
CN2
C Option Card connector
A Option Card mounting spacer
(Provided with A Option Card)
Option Clip
(To prevent raising of
C and D Option Card)

PG Speed Control Card Terminals and Specifications

PG-B2 Option Card
Input/Output Specifications
Terminal No.
1
Power supply for pulse generator
2
3
Pulse input terminals phase A
TA1
4
5
Pulse input terminals phase B
6
1
Pulse monitor output terminals
phase A
2
TA2
3
Pulse monitor output terminals
phase B
4
TA3 (E) Shield connection terminal
A Option Card
Fig 2.14 Mounting Option Cards
Table 2.12 PG-B2 I/O Specifications
Contents
12 VDC (±5%), 200 mA max.
0 VDC (GND for power supply)
H: +8 to 12 V (max. input frequency: 50 kHz)
GND pulse input phase A
H: +8 to 12 V (max. input frequency: 50 kHz)
GND pulse input phase B
Open collector output, 24 VDC, 30 mA max.
Open collector output, 24 VDC, 30 mA max.
-
C Option Card mounting spacer
C Option Card
D Option Card
D Option Card mounting spacer
A Option Card mounting spacer
Specifications
2
25
2-