User Constants - Omron VARISPEED L7 Manual

User Constants

The factory settings of each parameter are given in the following table. They are for a 200 V Class Inverter
with 3.7 kW.
No.
A1-00 Language selection for Digital Operator display
A1-01 Parameter access level
A1-02 Control method selection
A1-03 Initialize
A1-04 Password
A1-05 Password setting
A2-01 to
User specified parameters
A2-32
b1-01 Reference source selection
b1-02 RUN command source selection
b1-06 Control input scan
b1-08 Run command selection in programming modes
b2-08 Magnetic flux compensation volume
b4-01 Timer function ON-delay time
b4-02 Timer function OFF-delay time
b6-01 Dwell frequency at start
b6-02 Dwell time at start
b6-03 Dwell frequency at stop
b6-04 Dwell time at stop
C1-01 Acceleration time 1
C1-02 Deceleration time 1
C1-03 Acceleration time 2
C1-04 Deceleration time 2
C1-05 Acceleration time 3
C1-06 Deceleration time 3
C1-07 Acceleration time 4
C1-08 Deceleration time 4
C1-09 Emergency stop time
C1-10 Accel/decel time setting unit
C1-11 Accel/decel time switching frequency
C2-01 S-curve characteristic time at acceleration start
C2-02 S-curve characteristic time at acceleration end
C2-03 S-curve characteristic time at deceleration start
C2-04 S-curve characteristic time at deceleration end
C2-05 S-curve Characteristic time below leveling speed
C3-01 Slip compensation gain
C3-02 Slip compensation delay time
C3-03 Slip compensation limit
C3-04 Slip compensation selection during regeneration
C3-05 Output voltage limit operation selection
C4-01 Torque compensation gain
C4-02 Torque compensation delay time constant
C4-03 Starting torque compensation (FWD)
C4-04 Starting torque compensation (REV)
C4-05 Starting torque compensation time constant
Name
Factory
Setting
Setting
0
2
0
0
0
0
–
0
1
1
1
0%
0.0 sec.
0.0 sec.
0.0 Hz
0.0 sec.
0.0 Hz
0.0 sec.
10.0 sec.
1.5 s
1
0.0 Hz
0.5 sec.
0.5 sec.
0.5 sec.
0.5 sec.
0.50 sec.
1.0
2000 msec
200%
1
1
1.00
*1
200 msec
0.0%
0.0%
10 msec
10
5
10-