Inverter Modes - Omron VARISPEED L7 Manual

Inverter Modes

The Inverter's parameters and monitoring functions are organized in five groups which make it easy to read
and adjust parameters.
The 5 modes and their primary functions are shown in the
Mode
Drive mode
Quick programming mode
Advanced programming mode
Verify mode
*1
Autotuning mode
*1. Always perform autotuning with the motor before operating in the vector control modes.
Table
Table 3.2 Modes
Use this mode to start/stop the inverter, to monitor values such as the frequency ref-
erence or output current and to read out fault informations or the fault history.
Use this mode to read and set the basic parameters.
Use this mode to read and set all parameters.
Use this mode to read and set parameters that have been changed from their factory-
set values.
Use this mode when using a motor with unknown motor data in the vector control
modes. The motor data are measured/calculated and set automatically.
This mode can also be used to measure the motor line-to-line resistance only.
3.2.
Primary function(s)
3
5
3-