Tuning Parameters: C - Omron VARISPEED E7 User Manual

Tuning Parameters: C

Acceleration/Deceleration: C1
Param-
eter Name
Number
Sets the acceleration time to accel-
Acceleration
C1-01 erate from 0 Hz to the
time 1
maximum output frequency.
Sets the deceleration time to decel-
Deceleration
C1-02 erate from the maximum output
time 1
frequency to 0 Hz.
Sets the acceleration time when the
Acceleration
C1-03 multi-function input "accel/decel
time 2
time 1" is set to ON.
Sets the deceleration time when the
Deceleration
C1-04 multi-function input "accel/decel
time 2
time 1" is set to ON.
Sets the deceleration time when the
Emergency stop
C1-09 multi-function input "Emergency
time
(fast) Stop" is set to ON.
Sets the frequency for automatic
acceleration/deceleration switch-
ing.
Accel/decel time If the output frequency is below the
C1-11 switching fre- set frequency: Accel/decel time 2
quency If the output frequency is above the
set frequency: Accel/decel time 1
The multi-function input "accel/
decel time 1" has priority.
S-Curve Acceleration/Deceleration: C2
Param-
eter
Name
Num-
ber
When the S-curve characteristic time is
set, the accel time will increase by only
half of the S-curve characteristic times
S-curve charac-
at start and
C2-01 teristic time at
end.
acceleration start
Run command
S-curve charac-
C2-02 teristic time at
T
acceleration end
The S-Curve characteristic times at
start and end of deceleration are fixed
to 0.2 sec. and can not be changed.
Description
Description
ON
OFF
Output frequency
C2-02
C2-01
C2-01 C2-02
-------------- - -------------- -
= + C1-01 +
accel
2 2
Change
Setting Factory during
Range Setting Opera-
tion
Yes
Yes
0.0 to 10.0
Yes
6000.0 sec.
Yes
No
0.0 to
0.0 Hz No
200.0
Change
Setting Factory during
Range Setting Opera-
tion
0.20
No
sec.
0.00
to
2.50
Time
0.20
No
sec.
User Parameter Tables
MEMO-
Access
BUS Reg- Page
Level
ister
4-11
Q 200H
6-15
4-11
Q 201H
6-15
A 202H 6-15
A 203H 6-15
A 208H 6-15
A 20AH 6-15
MEMO-
Access
BUS Page
Level
Register
A 20BH 6-16
A 20CH 6-16
5-15