Omron VARISPEED E7 User Manual page 65

Cable-End Sleeves for Signal Lines
Models and sizes of straight solderless terminals are shown in the following table.
Wire Size mm
0.25 (24)
0.5 (20)
0.75 (18)
1.25 (16)
2 (14)
Wiring Method
Use the following procedure to connect wires to the terminal block.
1. Loosen the terminal screws with a thin-slot screwdriver.
2. Insert the wires from underneath the terminal block.
3. Tighten the terminal screws firmly
Strip the end for
7 mm if no cable-
end sleeve
used.
2-28
Table 2.13 Straight Solderless Terminal Sizes
2
Model
(AWG)
AI 0.25 - 8YE
AI 0.5 - 8WH
AI 0.75 - 8GY
AI 1.5 - 8BK
AI 2.5 - 8BU
Fig 2.14 Cable-End Sleeve Size
Screwdriver
is
Solderless terminal or wire
without soldering
Wires
Fig 2.15 Connecting Wires to Terminal Block
d1 d2 L
0.8 2 12.5
1.1 2.5 14
1.3 2.8 14
1.8 3.4 14
2.3 4.2 14
Blade of screwdriver
Control circuit
terminal block
Blade thickness: 0.6 mm max.
Manufacturer
Phoenix Contact
3.5 mm max.