Omron VARISPEED E7 User Manual page 273

Comparing Inverter Parameters and Digital Operator Parameter Set Values (VERIFY)
To compare Inverter parameters and Digital Operator parameter set values, use the following method.
Step
No.
1
2
3
4
5
6
7
If an fault is displayed, press any key to cancel the fault display and return to the o3-01 display. Fault displays
and their meanings are shown below. (Refer to
Application Precautions
When using the copy function, check that the following settings are the same between the Inverter and the
Digital Operator.
• Inverter product and type
Software number
•
• Inverter capacity and voltage
6-116
Digital Operator Display
LED Digital Operator LCD/HOA Digital Operator
-ADV-
** Main Menu **
Press the MENU key until the Advanced Pro-
gramming Mode is reached.
Programming
-ADV-
Press the DATA/ENTER key to enter the Func-
Initialization
tion Selection Display in Advanced Program-
A1 - 00 = 1
ming Mode.
Select Language
-ADV-
Scroll to Parameter o3-01 (Copy Function
COPY Function
Selection) using the Increment key and Decre-
o3
- 01=0
ment key.
Copy Funtion Sel
-ADV-
Copy Function Sel
Press the DATA/ENTER key to enter the
o3-01= 0
*0*
Parameter Setting Display.
COPY SELECT
-ADV-
Copy Funtion Sel
Change the set value to 3 using the Increment
o3-01= 3
*0*
key.
OP INV VERIFY
-ADV-
VERIFY
Press the DATA/ENTER key. The VERIFY
DATA VERIFYING function will start.
-ADV-
VERIFY
When the VERIFY function is completed
VERIFY COMPLETE
"End" respectively "Verify Complete is dis-
played on the Digital Operator for appr. 1 sec-
ond. Then the display returns to the Monitor
-ADV-
Display and parameter o1-03 is automatically
Copy Function Sel
reset to 0.
o3 -
01 = 0
*0*
COPY SELECT
Chapter 7, Digital Operator Copy Function
Explanation
Faults.)