Omron VARISPEED E7 User Manual page 146

Param-
eter Name
Number
Sets the initial value of the fan
Fan operation operation time.
o2-10
time setting The fan operation time is accumu-
lated from the set value.
0: No change
Fault trace initial-
o2-12 1: Initialized. After setting "1" o2-
ize
Resets the monitor parameters
kWh monitor ini- U1-29 and U1-30 back to zero.
o2-14
tialize 0: No change
1: Reset to zero
If set to 0 the HAND key on the
HOA Digital Operator is disabled
and the Inverter will not enter the
HAND Key func-
o2-15 HAND mode and start to run when
*3
tion selection
the HAND key is pressed.
0: HAND key disabled
1: HAND key enabled
Selects whether the Inverter is in
standard (IP00 or NEMA 1 / IP20)
Standard / IP54
o2-17 or IP54 protection class.
Selection
0: IP00 or NEMA 1 / IP20
1: IP54
*1. This parameter is effective only when the LED or LCD Digital Operator is used.
*2. The factory setting depends on the Inverter capacity. The value for a 200 V Class Inverter of 0.4 kW is given.
*3. This parameter is effective only when the HOA operator JVOP-162 is used.
*4. Factory setting depends on the protection class of the Inverter.
*5. The access level depends on the setting of o2-09: When o2-09 is set to "2" or "5" parameter o2-17 is accessable.
Copy Function: o3
Param-
eter Name
Number
0: Normal operation
Copy function 1: READ (Inverter to Operator)
o3-01
selection 2: COPY (Operator to Inverter)
3: Verify (compare)
Read permission 0: READ prohibited
o3-02
selection 1: READ permitted
Description
12 will return to "0"
Description
User Parameter Tables
Change
Setting Factory during Access
Range Setting Opera- Level
tion
0 to
0 hr. No A
65535
0 or 1 0 No A
0 or 1 0 No A
0 or 1 0 No A
*4 *5
0 or 1 No
Change
Setting Factory during Access
Range Setting Opera- Level
tion
0 to 3 0 No A
0 or 1 0 No A
MEMO-
BUS Page
Register
50EH 6-112
511H 6-112
512H 6-112
513H 6-113
51BH 6-113
MEMO-
BUS Page
Register
515H 6-113
516H 6-113
5-39