Setting User Parameters using the LED Digital Operator
Below in
Table 3.3
the procedure to change C1-01 (Acceleration Time 1) from 10 sec. to 20 sec. is shown
using the LED Digital Operator
Table 3.3 Setting User Parameters in Advanced Programming Mode using the LED Digital Operator
Step
Digital Operator Display
No.
1
2
3
4
5
6
7
8
9
10
11
.
Description
Power supply turned ON.
Press the MENU key to enter the Mode Selec-
tion Display.
Press the MENU key to scroll through the
Mode Selection Display.
Press the DATA/ENTER key to access the
Monitor Display in Advanced Programming
Mode.
Press the Increment or Decrement key until
C1-01 (Acceleration Time 1) is displayed.
Press the DATA/ENTER key to access the set-
ting display. The setting can be changed now.
Press the Shift/RESET key to move the flash-
ing digit to the right.
Press the Decrement key to change the value to
20.00sec.
Press the DATA/ENTER key to validate the
new setting. "End" is displayed for 1 sec., then
the new parameter setting for 0.5 sec.
The display returns to the Monitor Display.
Modes
3-13