Omron VARISPEED E7 User Manual page 119

Param-
eter
Number
PI reverse output
b5-11
selection
Selection of PI
b5-12 feedback signal
loss detection
PI feedback loss
b5-13
detection level
PI feedback loss
b5-14
detection time
Sleep function
b5-15
operation level
Sleep operation
b5-16
delay time
Accel/decel time
b5-17
for PI reference
PI Setpoint Selec-
b5-18
tion
b5-19 PI Setpoint
PI Setpoint Scal-
b5-20
ing
Sleep Function
b5-21
Selection
5-12
Name Description
0: Limit to 0 when PI output is
negative.
1: Reverses when PI output is neg-
ative.
Limit to 0 is also active when
reverse operation disabled is
selected by b1-04.
0: No detection of PI feedback
loss.
1: Detection of PI feedback loss.
Operation continues during
detection, the fault relay is not
operated.
2: Detection of PI feedback loss.
The motor coasts to stop at
detection, and the fault relay
operates.
Sets the PI feedback loss detection
level as percentage using the maxi-
mum output frequency as 100%.
Sets the PI feedback loss detection
time.
Sets the sleep function start level as
a frequency.
Sets the delay time until the sleep
function starts.
Sets the accel/decel time for the PI
Softstarter (SFS).
0: Disabled
1: Enabled
PI target value
Sets the unit for b5-19, U1-38 and
U1-24
0: 0.01 Hz
1: 0.01% (the maximum output
frequency E1-04 is taken as
100%.
2 – 39: rpm, set value is equal to
motor poles
40 – 39999: User desired display
Sets the display value
for 100 %.
Sets the number of
decimal digits.
Sets the operation method of the PI
sleep function
0: PI Setpoint
1: SFS Input
2: Snooze
Change
Setting Factory during Access
Range Setting Opera- Level
tion
0 or 1 0 No A
0 to 2 0 No A
0 to
0% No A
100
0.0 to
1.0 sec. No A
25.5
0.0 to
0.0 Hz No A
200.0
0.0 to
0.0 sec. No A
25.5
0.0 to
0.0 sec. No A
25.5
0 to 1 0 No A
0.00 to
100.00 0 Yes A
%
0 to
1 No A
39999
0 to 2 1 No A
MEMO-
BUS Page
Register
1AFH 6-87
1B0H 6-87
1B1H 6-87
1B2H 6-87
1B3H 6-87
1B4H 6-87
1B5H 6-87
1DCH 6-87
1DDH 6-87
1E2H 6-87
1E3H 6-87