Software Setting of I/O Allocations
Note
6-7
Software Setting of I/O Allocations
60
The CompoNet Communications Unit will set the baud rate when it estab-
lishes communications with the CompoNet Master Unit. It will save the baud
rate until the power supply is turned OFF.
If you change the baud rate of the CompoNet Master Unit, reset the power
supply of the CompoNet Communications Unit.
You can set Dummy Units in a Software Setting Table for SmartSlice I/O Units
that are not in the SmartSlice I/O Terminal. The settings include the node
numbers and I/O configurations.
When you then add the SmartSlice I/O Units, it will not be necessary for you
to set the unit numbers or I/O configurations. It will also not be necessary to
change the ladder programming very much.
The Software Setting Table contains the I/O configuration information (includ-
ing the Dummy Units). You can use the CX-Integrator to set or read it.
Section 6-7