Omron GRT1-CRT - 05-2008 Operation Manual page 27

Specifications
8
Item
Communications You can use these cables:
media
Round Cable I (JIS C 3306, VCTF 2-core 0.75-mm
pair cable)
Round Cable II (JIS C 3306, VCTF 4-core 0.75-mm
pair cable)
Flat Cable I (without sheath, DCA4-4F10)
Flat Cable II (with sheath, DCA5-4F10)
Note The Round Cable I, Round Cable II, Flat Cable I, and
Indicators MS (green/red): This indicator shows the status of the Compo-
Net Communications Unit.
NS (green/red): This indicator shows the communications sta-
tus of the CompoNet network.
TS (green/red): This indicator shows the status of the Smart-
Slice I/O Terminal.
UNIT PWR (green): This indicator shows the status of the Unit
power supply.
I/O PWR (green): This indicator shows the status of the I/O
power supply.
Switches Rotary switches: There are two rotary switches. You use them
to set the node address.
DIP switch: There is one DIP switch with four pins. You use
them to set the operating mode.
Connectors There is one CompoNet communications connector.
Terminals Clamp terminals for Unit power supply (24 VDC)
Clamp terminals for I/O power supply (24 VDC)
Power consumption 2.5 W
Power consumption 80 W max.
for each SmartSlice (You must divide the I/O Terminal into blocks to use more than
I/O Terminal block 80 W.)
SmartSlice I/O Ter- Main block and a maximum of two expansion blocks
minal blocks
Current consump- 4 A max.
tion for I/O power
supply
Weight 125 g
Accessories None
Specification
Flat Cable II are different types of cable. You must use a
Repeater to divide a branch line from the main line to
use more than one type of cable.
Section 1-4
2
twisted-
2
twisted-