Installation of Configuration Software
2-5
Installation of Configuration Software
2-5-1
Installation Requirements
2-5-2
Installation Procedure
DTM Installation
1,2,3...
28
In order to operate the GRT1-PRT and the SmartSlice I/O system the PROFI-
BUS DP Master needs to be configured for communication with the GRT1-
PRT. For this purpose OMRON provides the GRT1-PRT DTM via the
OMRON web site http://www.omron-industrial.com/
After installation the DTM will run in the OMRON Cx-Profibus FDT Container,
allowing the user to setup the I/O configuration and setting the parameters of
both the GRT1-PRT as well as individual SmartSlice I/O Units.
Note To fully utilize the features of the GRT1-PRT and the SmartSlice I/O system, a
PROFIBUS DP-V1 Class 2 capable Master Unit and DTM are required. The
OMRON CS1/CJ1W-PRM21 Master units provide this functionality as of ver-
sion 3.0.
The following are the minimum requirements for a PC to install the GRT1-
PRT DTM configuration software:
• PC Pentium III or higher, 500 MHz minimum
• Operating System:
• RAM:
• Hard disk space:
• Graphics resolution:
• Installed FDT Container software, e.g. OMRON's Cx-Profibus.
This section explains how to install the Cx-Profibus Configuration software
and its components for the PROFIBUS Master Unit.
1. Exit all other Windows-based programs.
2. Double-click the file GRT1PRT_SmartSlice_IO_Coupler_Setup.exe.
The setup program for the GRT1-PRT DTM will start. A progress dialog
window is displayed, indicating progress of the setup as the program is
loaded.
3. The setup program will check the version of the CS1/CJ1W-PRM21
PROFIBUS Master DTM installed. Running the GRT1-PRT requires a
Master DTM version of 0.7.0.0. or higher. If this version is not installed, the
following warning screen will pop up.
The appropriate version of the CS1/CJ1W-PRM21 Master DTM is avail-
able through OMRON's web site. Pressing the OK button, will continue
with installation.
Windows 2000 SP2 / Windows NT 4.0, SP6 /
Windows XP
256 MB minimum
256 MB minimum
1024 x 768 pixels minimum
Section 2-5