Connecting the Power Supply Cables
Disconnecting Wires or Ferrules
4-2-4
Connecting the Unit Power Supply Cables
■
Connecting Wires without Ferrules
Press in the release button adjacent to the connection hole of the screwless
clamp terminal with a small flat-blade screwdriver. Then push the wire fully
into the wire hole of the screwless clamp terminal and release the button.
Small flat-blade screwdriver
Release button
Press in the release button adjacent to the connection hole of the screwless
clamp terminal with a small flat-blade screwdriver. Then pull out the wire or
ferrule and release the button.
Small flat-blade screwdriver
Release button
We recommend this screwdriver to connect or disconnect wires or ferrules.
Model: SZF1 Flat-blade Screwdriver
Manufacturer: Phoenix Contact
Side
Front
0.6 mm
3.5 mm
Connect the Unit power supply cable (24 VDC) to the power supply terminals
on the CompoNet Communications Unit. These terminals send power to the
internal circuits of the CompoNet Communications Units and the SmartSlice I/
O Units.
Section 4-2
33