Omron GRT1-CRT - 05-2008 Operation Manual page 123

Error Procedures with CX-Integrator
More Information on Errors in SmartSlice I/O Units
Error code Error description
(hexadecimal
value)
0300 Reception error for backup
data
0374 Transmission error
Cause
A transmission error
occurred.
0375 Communications stopped
because of a transmission
error
Cause
A transmission error
occurred when the Unit
was set to stop communi-
cations for transmission
errors.
0376 Slave duplication error
Cause
A Slave duplication error
occurred.
0378 I/O size error
0379 SmartSlice configuration
error
104
"Detail"
1st byte 2nd byte
0x80: Node addresses
SmartSlice (hexadecimal
I/O value)
0x80: Node addresses
SmartSlice (hexadecimal
I/O value)
0x80: Node addresses
SmartSlice (hexadecimal
I/O value)
0x80: Node addresses
SmartSlice (hexadecimal
I/O value)
0x00 0x00
0x00 0x00
Keeping error Procedure
history during
power
interruptions
Not kept • Make sure that the
SmartSlice I/O Units are
correctly connected.
• Make sure that there
are no sources of noise
near the Unit.
Not kept • Make sure that the
SmartSlice I/O Units are
correctly connected.
• Make sure that there
are no sources of noise
near the Unit.
Kept • Make sure that the
SmartSlice I/O Units are
correctly connected.
• Make sure that there
are no sources of noise
near the Unit.
Not kept Make sure that the
SmartSlice I/O Units are
connected correctly and
then reset the Compo-
Net Communications
Unit.
Not kept Make sure that the
SmartSlice I/O Units are
connected correctly and
then reset the Compo-
Net Communications
Unit.
Not kept Make sure that the
SmartSlice I/O Units are
connected correctly and
then reset the Compo-
Net Communications
Unit.
Section 9-2