Installing a SmartSlice I/O Terminal
3-1
Installing a SmartSlice I/O Terminal
3-1-1
Installing the CompoNet Communications Unit
Necessary Tools
Installation Direction
Installation Procedure
1,2,3...
22
This section tells you how to install the CompoNet Communications Unit and
SmartSlice I/O Units.
You install the CompoNet Communications Unit and SmartSlice I/O Units on
DIN Track.
Name
35-mm DIN Tracks
PFP-50N
PFP-100N
PFP-100N2
End Plate
PFP-M
You can install the SmartSlice I/O Terminal in these directions.
1. Install the DIN Track.
Use one screw for each three holes in the DIN Track. There must be a
screw for each 105 mm or less.
One screw for each three holes
Model
Length: 50 cm
Length: 100 cm
Length: 100 cm
Two End Plates are necessary
for each SmartSlice I/O Termi-
nal block.
DIN Track
Section 3-1
Remarks