Parameter Operations List - Omron E5AK PROGRAMMABLE TYPE User Manual

PARAMETER OPERATIONS LIST

• Switching to modes other than the manual or protect mode is carried out by mode selection in
the menu display.
• The figure below shows all parameters in the order that they are displayed. Some parameters are
not displayed depending on the protect mode setting and conditions of use.
Level 0
PV/Present SP
Pattern No.
Step No. monitor
Hold
Advance
Standby time monitor
Pattern elapsing time monitor
Pattern execution count monitor
MV monitor (heat)
MV monitor (cool)
Valve opening monitor
Power ON
1 second min.
Level 0
1 second min.
Program
1 second min.
Level 1
1 second min.
Level 2
1 second min.
Setup mode
1 second min. Expansion
mode
1 second min.
Option mode
1 second min.
Calibration
mode
Program
Pattern No.
Number of steps
to Step 0 to 7 SP
to Ramp rate 0 to 7
to Step 0 to 7 time
to Step 8 to 15 SP
to Step 8 to 15 time
Pattern execution count
Alarm value 1
Alarm value 2
Alarm value 3
Time signal 1 step selection
Time signal 1 ON time
Time signal 1 OFF time
Time signal 2 step selection
Time signal 2 ON time
Time signal 2 OFF time
PARAMETER OPERATIONS LIST
+
1 second min.
Manual mode
1 second min.
+
RUN/RST RUN/RST
1 second min. 1 second min.
Protect mode
+
RUN/RST
1 second min.
Parameters in a mode can be
switched by the
eter following the last parameter is the
top parameter of the mode.
Level 1
AT Execute/Cancel
Proportional band
*1 Integral time
*1 Derivative time
Cooling coefficient
Dead band
Position-proportional dead band
Manual reset value
Hysteresis (heat)
Hysteresis (cool)
Control period (heat)
Control period (cool)
Heater current monitor
Heater burnout
*1
In the rate of rise setting, Target SP 0
to 7 and Soak time 0 to 7.
+
key. The param-
A--13