Omron E5AK PROGRAMMABLE TYPE User Manual page 21

J Selecting
parameters
J Fixing settings
• Protected modes cannot be selected. Also, the menu display does not
appear when modes are protected up to the program mode.
• If you select [ ], [
the level 0, program, level 1 and level 2 modes, respectively, are se-
lected.
These modes are selected with control still continuing.
• If you select[ ] [
setup, expansion, option and calibration modes, respectively, are se-
lected.
When these modes are selected, the control is reset. So, control out-
puts and auxiliary output are turned OFF. When another mode is se-
lected while in these modes control, reset is canceled.
• To set the controller to the protect mode or to return to the level 0
mode from the protect mode, press the
simultaneously for 1 second minimum.
• To set the controller to the manual mode, press the
second minimum with the
modes. To return to the level 0 mode in the manual mode, press the
key for one second minimum with the
to press the key first in this operation.
• When the controller is not in the manual mode, each press of the
key switches the parameter in the respective mode.
Parameter
Parameter
1
• If you press the key when at the final parameter, the display re-
turns to the top parameter for the current mode.
• When you change parameter settings or contents, specify the parame-
ter using the or
two seconds or press the
• When another mode is selected, the content of the parameters before
the mode was selected is fixed.
• When you turn the power OFF, you must first fix the settings and pa-
rameter contents (by pressing the
mode). The settings and parameter contents are sometimes not
changed by merely pressing the
1.4 Parameters and Menus
], [ ] or [ ] in the menu display,
] [ ] or [ ] in the menu display, the
RUN/RST
key held down in the level 0 to 2
Parameter
2 3
keys, and either leave the setting for at least
key. This fixes the setting.
key or selecting another
or keys.
key and the key
key for one
key pressed. Be sure
Parameter
n
1--11