Level 1 Mode - Omron E5AK PROGRAMMABLE TYPE User Manual

• The parameters in this mode can be used only when the "security" parameter
(protect mode) is set to "0" to "3".
• This mode contains the main parameters for adjusting control, such as executing
AT (auto-tuning), setting the control period, setting PID parameters and setting
heater burnout (HBA) conditions.
• To select this mode, press the
to the menu display. If you select [
mum, the controller enters the level 1 mode.
• To select parameters in this mode, press the
tings, use the or
• The following table shows the parameters supported in this mode and the page
where the parameter is described.
Symbol
AT Execute/Cancel
Proportional band
Integral time
Derivative time
Cooling coefficient
Dead band
Position-proportional dead band
Manual reset value
Hysteresis (heat)
Hysteresis (cool)
Control period (heat)
Control period (cool)
Heater current monitor
Heater burnout
key for 1 second minimum. The display changes
] then press the
keys.
Parameter Name

Level 1 Mode

key for 1 second mini-
key. To change parameter set-
Page
5-18
5-18
5-18
5-18
5-19
5-19
5-20
5-20
5-21
5-21
5-22
5-22
5-23
5-23
5--17