Option Mode - Omron E5AK PROGRAMMABLE TYPE User Manual

CHAPTER 5 PARAMETERS

Option Mode

• The parameters in this mode can be used only when the "security" parameter
(protect mode) is set to "0" and "1".
• You can select this mode only on controllers that support optional functions. In
this mode, you can set the communications conditions, transfer output and event
input parameters to match the type of optional function supported on the control-
ler. This mode also contains the parameters for the heater burnout alarm (HBA)
function and position-proportional travel time.
• To select this mode, press the
to the menu display. If you select [
press the
• To select parameters in this mode, press the
tings, use the
• The following table shows the parameters supported in this mode and the page
where the parameter is described.
5--46
key for 1 second minimum, the controller enters the option mode.
or keys.
Symbol
Event input assignment 1
Event input assignment 2
Event input assignment 3
Event input assignment 4
Communication stop bit
Communication data length
Communication parity
Communication baud rate
Communication unit No.
Transfer output type
Transfer output upper limit
Transfer output lower limit
HBA latch
Motor calibration
Travel time
PV dead band
key for 1 second minimum. The display changes
] using the and
key. To change parameter set-
Parameter Name
keys, and then
Page
5-47
5-47
5-47
5-47
5-48
5-48
5-48
5-48
5-48
5-49
5-49
5-49
5-50
5-50
5-51
5-51