Level 0 Mode - Omron E5CK Datasheet

■ Parameters Operation

Level 0 Mode

1 3 0 0
0
s p - m
0
o
50.0
c - o
50.0
r - 5
run
s e c r
1
k e y p
off
3 8. 8
Process value
16.0 Manipulated variable
MANU indicator
PV/SV
The process value is displayed on the No.1 display and the set point is displayed on the No.2 display.
When the multi-SP function is in use, the value of whichever is set, set point 0 or 1, is linked.
Set Point During SP Ramp
Monitors the set point when the SP ramp function is used.
MV Monitor (Heat)
MV Monitor (Cool)
Used when the Unit is in heating and cooling control operation.
Run/Stop
Security
Any mode marked with "X" in the following table is not displayed on the menu when this parameter is set to
"0" to "3."
Mode Set value
0 1
Calibration x
Option
Expansion
Setup
Level 2
Level 1, 0
The Unit will be in only level 0 mode and the menu will not be available when this parameter is set to "4" to
"6."
Only the "PV/SP monitor" and "set point" parameter can be used when this parameter is set to "5."
Only the "PV/SP monitor" parameter can be used when this parameter is set to "6."
A/M Key Protect
Invalidate the function of the A/M Key.
MV Manual
2 3 4
x x x
x x x
x x x
x x x
x x
x
Digital Controller
E5CK
I-75