Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual page 160

Hard disk drive (HDD) / solid state disk (SSD)
Figure 69: Connecting cables to the 10x 3.5-inch HDD backplane
▶ Connect the following cables to the HDD backplane:
1 SAS/SATA cable
2 SAS/SATA cable
3 Power cable
4 SAS/SATA cable
5 OOB cable
The cables are equipped with labels showing the right connector.
For the cable plan, see
CAUTION
Incorrect cabling may cause wrong LED identification of the HDD/SSD.
Misleading LED could lead to swapping out the wrong HDD/SSD, and
that will result in data loss.
▶
Check the correct cabling using the labels on the cables and the
cable plans.
Concluding steps
160
"Appendix B" on page
Upgrade and Maintenance Manual
559.
RX2540 M7