Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual page 361

Figure 220: Installing the EVAC CPU heat sink
▶ Install the EVAC CPU heat sink in the same way.
▶ Fasten the two additional screws in any order (see circles).
Torque: 0.6 Nm
Upgrading the main memory
▶ Select an adequate memory configuration for "2 CPUs populated", see
"Basic information" on page
▶ Install memory modules, see
▶ Install dummy memory modules in empty slots, see
modules" on page
Installing three additional fan modules
▶ Install three fan modules in bays 4, 5 and 6, see
on page 244.
RX2540 M7
350.
"Installing memory modules" on page
341.
Upgrade and Maintenance Manual
Processor (CPU)
"Installing memory
"Installing the fan module"
341.
361