Hard disk drive (HDD) / solid state disk (SSD)
7.5.5
Replacing the 10x 3.5-inch HDD backplane
Field Replaceable Unit
(FRU)
Tools:
Phillips PH2 / (+) No. 2 screw driver
Preliminary steps
▶
"Locating the defective server" on page
▶ If applicable,
"Removing the front cover with lock" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
▶
"Removing the fan cage" on page
▶ Release all HDD modules and pull them out a few centimeters, see
"Removing 3.5-inch HDD modules" on page
CAUTION
The HDD modules need not to be removed.
▶
If you want to remove them nevertheless, check if all HDD
modules are uniquely identified so that you can reinsert them
into their original bays.
▶ Release all dummy modules and pull them out a few centimeters, see
"Removing a 3.5-inch HDD dummy module" on page
Removing the defective 10x 3.5-inch HDD backplane
▶ If applicable, remove the internal RAID riser module, see
internal RAID riser module" on page
▶ Disconnect all cables from the HDD backplane.
158
50.
76.
303.
Upgrade and Maintenance Manual
Hardware: 15 minutes
47.
50.
55.
153.
151.
"Removing an
49.
RX2540 M7