States Of Power-On Indicator And Time Duration During Firmware Restore - Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual

For more information about the iRMC flash procedure, see "Basic
software procedures" in the "FUJITSU Server PRIMERGY RX2540 M7
Upgrade and Maintenance Manual".
HDD prefailure detection
Depending on your hardware configuration HDD prefailure detection will be
supported.
The requirements are:
– iRMC S6 Firmware
– supported OOB RAID system
18.2.2.3 States of power-on indicator and time duration during
firmware restore
The power-on indicator changes as follows from the time the power cord is
connected until firmware restore is completed after system board replacement.
During the firmware restoration, the ID indicator flashes in blue as shown in the
following table.
RX2540 M7 Upgrade and Maintenance Manual
Appendix A
541