Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual page 517

Figure 346: Touch points of the system board
▶ Notice the handle of the system board (see circle).
▶ Hold the system board on the handle and lift the system board carefully out
of the chassis in a slight angle. Thereby you pull the connectors out of the
I/O panel.
CAUTION
▶
Always take the system board with both hands!
▶
Never lift the system board one-sided or at a heat sink,
because the solder connections between the socket and the
system board come under tension and increase the risk of
damage and malfunction!
▶
Do not damage the EMI springs which are essential to comply
with applicable EMC regulations and satisfy cooling
requirements and fire protection measures.
▶ Place the removed and the new system board on an antistatic surface.
▶ Remove the TPM, see
RX2540 M7
"Removing the TPM" on page
Upgrade and Maintenance Manual
System board and components
497.
517