Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual page 221

Connecting the M.2 interposer board
Figure 112: Connecting the M.2 interposer board
▶ Connect the M.2 interposer board cable to M.2 interposer board.
▶ Insert the M.2 interposer board cable in the cable clamp (A).
▶ Run the M.2 interposer board cable in the guide rail.
▶ Connect the M.2 interposer board cable to the connector "INTERPOSER 1"
on the system board (see circles).
▶ Connect the power cable to M.2 interposer board.
▶ Run the power cable over the M.2 interposer board cable.
▶ Connect the power cable to connector "PWR M2" on the system board.
Concluding steps
▶ If applicable,
"Installing the SAS expander board holder" on page
▶ If applicable, install the riser module 2, see
page 74.
RX2540 M7
Hard disk drive (HDD) / solid state disk (SSD)
A
Upgrade and Maintenance Manual
"Installing a riser module" on
205.
221