Installing The M.2 Interposer Board - Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual

Replacing the M.2 SSD
▶ Remove the defective M.2 SSD, see
▶ Install the new M.2 SSD, see
Concluding steps
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶
"Setting boot priority" on page
▶ If applicable,
"Installing the front cover with lock" on page
▶ For non-array configurations, ask the customer or service engineer to install
the operating system or restore the data after the parts have been replaced.
Software configuration
To install the ESXi to the M.2 SSD, see
page 215.
7.8.5

Installing the M.2 interposer board

The M.2 interposer board is an option.
Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver
Preliminary steps
▶
"Locating the defective server" on page
▶ If applicable,
"Removing the front cover with lock" on page
RX2540 M7
Hard disk drive (HDD) / solid state disk (SSD)
"Removing an M.2 SSD" on page
"Installing an M.2 SSD" on page
59.
65.
71.
120.
Upgrade and Maintenance Manual
"Software configuration" on
Hardware: 10 minutes
47.
216.
212.
71.
49.
219