Completing The Maintenance Task; Updating Or Recovering The Bios And Irmc S6 - Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual

Basic software procedures
For more information on how to access the BIOS and modify settings,
see the corresponding BIOS Setup Utility reference manual. To change
the boot order before or after device replacement, please refer to
"Setting boot priority" on page
5.3

Completing the maintenance task

5.3.1

Updating or recovering the BIOS and iRMC S6

For Japan:
Follow the instructions provided separately.
The latest BIOS and iRMC versions and their corresponding manuals are
available from the Fujitsu support internet pages at:
https://ts.fujitsu.com/support/
For Japan:
https://www.fujitsu.com/jp/products/computing/servers/primergy/downloads/
When the system board is replaced, the BIOS and iRMC versions which
were being used can be restored by removing the iRMC microSD card
from the original system board and installing it on the replaced system
board.
The iRMC microSD card on the system board contains the BIOS/iRMC
firmware that is running.
After replacing the system board, the operating version number will be
restored based on this information. Do not replace the system board and
the iRMC microSD card at the same time.
Note on the boot watchdog
Before updating or recovering the BIOS and iRMC, ensure that the boot
watchdog is disabled, see
After updating or recovering the BIOS and iRMC, enable the boot
watchdog again, see
Fujitsu does not assume responsibility for any damage done to the
server or for the loss of any data resulting from BIOS updates.
94
120.
"Disabling the boot watchdog" on page
"Enabling the boot watchdog" on page
Upgrade and Maintenance Manual
90.
101.
RX2540 M7