Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual page 508

System board and components
If ServerView related tools are applied (i.e. ServerView Agentless Service or
ServerView ESXi CIM Provider) or BIOS is executed at the same time as the
power cord is connected after the iRMC microSD card replacement, see
"iRMC S6 firmware recovery guidelines after replacing an iRMC microSD
card" on page 509
microSD card" on page
Check with the system administrator for the ServerView related tools.
Preliminary steps
▶
"Locating the defective server" on page
▶ If applicable,
"Removing the front cover with lock" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
▶ If applicable, remove the expansion card from slot 5 and slot 6, see
"Removing an expansion card" on page
Replacing the iRMC microSD card
▶ Remove the defective iRMC microSD card, see
microSD card" on page
CAUTION
(not valid for Europe, Middle East, India and Africa)
The iRMC microSD card contains customer information.
▶
After removing the iRMC microSD card, hand the card over to
the customer.
▶
If the customer requests disposal of the defective microSD card,
proceed as follows: Using a pair of side-cutting pliers, cut the
microSD card in half.
▶ Install the new iRMC microSD card, see
on page 504.
508
and "BIOS recovery guidelines after replacing an iRMC
509.
506.
Upgrade and Maintenance Manual
47.
50.
50.
55.
278.
"Removing the iRMC
"Installing the iRMC microSD card"
49.
RX2540 M7