Verifying The Memory Mode - Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual

▶ Enter the BIOS.
▶ Select the Configuration menu.
▶ Select the status menu of the desired component:
▶ Select PCI Status for expansion cards.
▶ Reset replaced components to Enabled.
▶ Save your changes and exit the BIOS.
For more information on how to access the BIOS and modify settings,
see the corresponding BIOS Setup Utility reference manual.
5.3.8

Verifying the memory mode

If a memory module fails, the server will reboot and the defective module will
be disabled. As a result, the current memory mode (e.g. Mirrored Channel
mode) may no longer be available due to a lack of identical memory module
pairs. In this case, the memory mode will automatically revert to Independent
Channel Mode.
For more information on memory modes available for your server, see
"Basic information" on page
After replacing the defective module(s) the memory mode is automatically
reset to its original state. It is recommended to verify that the memory mode
has been correctly.
▶ Enter the BIOS.
▶ Select the Configuration menu.
▶ Select Memory Status and verify that none of the memory modules are
marked as Failed.
▶ Select Memory Configuration to verify Memory Mode.
▶ Save your changes (if applicable) and exit the BIOS.
For more information on how to access the BIOS and modify settings,
see the corresponding BIOS Setup Utility reference manual.
RX2540 M7
332.
Upgrade and Maintenance Manual
Basic software procedures
103